computer33
07-09-2005, 06:37 PM
Hi,
Any suggestions would be appreciated. Yesterday, I upgraded my hard drive from 80gig to 200gig so I could fit more recordings.
This should not have been a problem because I had Sage installed on another drive. I was only using the 80gig as storage and not for program installations.
Now, I start SageTV and no epg. Ok. I go throught the wizard and re-establish the zap2it listings. Everything ok until I want to run sage service.
I start SageTVServiceControl.exe and then start SageTv.exe and my epg data is gone. Even if I go through the wizard and enter '00000' Rogers Cable Toronto does not appear?
If I stop the service and simply start SageTv.exe alone without the SageTVServiceControl.exe and go through the wizard then everything is fine again.
Any help?
Any suggestions would be appreciated. Yesterday, I upgraded my hard drive from 80gig to 200gig so I could fit more recordings.
This should not have been a problem because I had Sage installed on another drive. I was only using the 80gig as storage and not for program installations.
Now, I start SageTV and no epg. Ok. I go throught the wizard and re-establish the zap2it listings. Everything ok until I want to run sage service.
I start SageTVServiceControl.exe and then start SageTv.exe and my epg data is gone. Even if I go through the wizard and enter '00000' Rogers Cable Toronto does not appear?
If I stop the service and simply start SageTv.exe alone without the SageTVServiceControl.exe and go through the wizard then everything is fine again.
Any help?