Remote Issues

[gplasky]

Decided to try and setup SageTV beta 1.4.8 with my USB-UIRT. Thought maybe I could simplify my Girder life. I am using a Phillips MCE Remote with it. I started learning the keys and everything was going fine until I reached 0,1, & 2. These 3 keys seemed to keep generating the same code in some instances. Where I learned 0 & 1 and then when I did 2 it said it was the same as 0 and do I want to change it. It became a comedy of errors because I would always get 2 out of the 3 before they wanted to start swapping. I say this is odd because I do use Girder and all the codes are unique. I also used myHTPC with a plugin that allowed me to use the USB-UIRT and again, all unique codes. Keep in mind the Phillips MCE remote does generate 2 unique codes for each key pressed and released. Don't think this is the issue because it would have showed up in the other programs. Any help would be appreciated.

Gerry

[salsbst]

My GML file, linked on the page in my signature, has a section for the MCE Remote. All the keys work.

HTH,
Stuart

[gplasky]

Actually I am using your gml file in Girder. Modified it and it is working quite well. I thought I would utilize Sage's capability of supporting the USB-UIRT and configure Sage itself for the remote work. The MCE Remote is working fine in Girder for me. It is when I have configured to use it in Sage, without Girder that I am having the duplicate shifting codes betwwen 0,1 & 2. Haven't seen this in the 2 other programs I have that can learn remote codes. (Girder and myHTPC)

Gerry