mrr19121970
08-20-2003, 10:38 AM
I've finally bought Sage Recorder when I saw that a command line was added. Now I can use Digiguide - or so I thought.
Is it possible to in addition to the start & end times specify a seconds before & after to force an over-record. ie start recording 45 seconds before show, and continue recording 60 seconds after the end.
The use of the double quotes around the commands causes a conflict in Girder - which I use to change the channel on my TIRA-1. Can you please change this to single quotes aswell/instead.
When recording/starting sage recorder via DigiGuide then a new sage is started. This fails on the build graphs, and also the pre running sage session freezes.
The mouse pointer is STILL visible on the full screen mode. I reported this as an error when I tried out V1.2
The screen saver is not deactivated when sage recorder is running.
Is it possible to in addition to the start & end times specify a seconds before & after to force an over-record. ie start recording 45 seconds before show, and continue recording 60 seconds after the end.
The use of the double quotes around the commands causes a conflict in Girder - which I use to change the channel on my TIRA-1. Can you please change this to single quotes aswell/instead.
When recording/starting sage recorder via DigiGuide then a new sage is started. This fails on the build graphs, and also the pre running sage session freezes.
The mouse pointer is STILL visible on the full screen mode. I reported this as an error when I tried out V1.2
The screen saver is not deactivated when sage recorder is running.