SageTV Community  

Go Back   SageTV Community > salsbst
Forum Rules FAQs Community Downloads Today's Posts Search


Conversation Between salsbst and sundansx
Showing Visitor Messages 1 to 1 of 1
  1. sundansx
    09-18-2011 07:04 PM
    A while back it appears that you had sagetv setup with girder, with usbuirt blasting to your cable/sat box. I am in the middle of a move to windows 7 64 bit and am forced to move off of 1394 channelchange to use the blaster. How did you have this set up? I am an experience sage and girder user, so you can be technical. I went this route because I am likely going to move to a hauppauge cable card before long and need an interim solution.
    I am guessing that you have to use multitunerexe to send girder events. I presume you have to setup girder 11 girder actions that are all the numbers and an enter for the cable box. Even though sagetv has USBUIRT support, I am guessing that girder and sage cannot share the device at the same time.

All times are GMT -6. The time now is 02:45 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2023, vBulletin Solutions Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.