For anyone that uses my Sage Pro theme for the default STV or the Sage Pro MC theme you now have an STV for your HD200 in Standalone Mode. It can give a consistent appearance between standalone and extender mode.
Installation
Unzip the package so that the "Cheetah" directory is at the root of your USB drive. (Or place the "Cheetah" directory on a network share that the HD200 has access to.)
Load the STV on the HD200
Plug the USB drive into the HD200, or make sure the network path is accessible to the HD200.
From the HD200's Main Menu, go to Settings -> System Information (or just use the Info command while on the Main Menu). Using the remote, enter the 4-digit '5309' code. If entered successfully, you will see a blue dot in the top left corner.
From the HD200's Main Menu, go to Settings -> Advanced Setup -> Advanced -> SageTV Application Package. Load the STV...
For a USB drive, use Up Directory to get to "/", then go to tmp/external/<name of the USB drive>, then navigate to the path where the .opt.stv file is located and load it. This will be the SagePro.opt.stv file.
For a network location, use Up Directory to get to "/", then go to tmp/sagetv_shares, then navigate to the path where the .opt.stv file is located and load it. This will be the SagePro.opt.stv file.
Once this file is loaded the standalone mode will refresh but still look the same. This is very important: YOU NEED TO POWER OFF THE HD200. (Pull the plug)ONLY AFTER IT IS POWERED OFF AND POWERED BACK ON WILL THE NEW SAGE PRO GUI LOAD.
For support or suggestions, see this forum thread here. Support Thread
Screenshots
Features
New Main Menu Icons! (same as my themes)
Almost every other icon is replaced!
New busy/wait cursor!
All new Weather icons!
