|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-15-2004, 11:19 AM
|
|||
|
|||
|
Problem with overlay mixer
I'am running SageTV .19 and do not seem the overlay rendering going correctly. As stressed earlier, I changed the NTSC registry key to 0 and the OSD height to 576 lines.
Now the following happens: - the OSD is visible but only the middle 75% is on screen (in horizontal direction, in vertical direction it is ok), the rest is not visible (do I need to change also the OSD width), - when I start watching a TV programme I get an error concerning the connection with the Overlay mixer When I disable the OSD, everything is back to normal and working. One other note, when I enable the OSD I cannot enable the 3D acceleration. Any suggestions??? 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Threaded Mode