|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-02-2005, 06:43 PM
|
||||
|
||||
|
PVR-500 with RF noise and Audio drop-outs
I replaced one of my two PVR-250's with a PVR-500 yesterday.
Since then, both tuners on the 500 have a significant amount of RF noise (wavy lines in the picture) and, whenever Sage is on those tuners, the audio constantly drops out. I am using Hauppauge's latest drivers 4.7A and Sage 3.0.11. Do I just have a bad unit or has anyone else seen this? Thanks 
|
|
#2
10-02-2005, 09:08 PM
|
||||
|
||||
|
Before someone with a 500 chimes in... that 500 is adding an extra internal split into the coax, if that is how you are connecting it. Maybe the signal strength just went too low after that internal split? If you have other splitters on the line, can you try connecting the coax from before your own last split?
- Andy
__________________
SageTV v7.1.9 is available here. - Read the SageTV FAQ and PDF User's Guides for SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. Before you ask: no, I can't say "when".
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
