|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-24-2005, 09:29 AM
|
|||
|
|||
|
hauppauge remote + ir.exe vs netmote+girder?
I am currently using sagetv version 2. I have all the basic stuff running. I recently read on the forums how to use the ir.exe program, a new updated irremote.ini along with my hauppauge 43 button remote to control SageTV. It seems to be working nicely.
Longer term, I am hoping to use a new Dell Axim 50v and NetRemote + Girder to control SageTV as well as other app's on the HTPC. However, I was wondering if I (or visitors to the HTPC room) can continue to use the hauppauge remote (along with ir.exe), and I can use Netremote+Girder. Or will there be a conflict there... Just wondering if anyone has gone down this road before? Thanks 
|
|
#2
10-24-2005, 09:49 AM
|
||||
|
||||
|
If you are not trying to control the same IR receiver w/Girder, then I don't see why there would be any sort of conflict. But, perhaps someone else knows of other issues you might run into?
- Andy
__________________
SageTV v7.1.9 is available here. - Read the SageTV FAQ and PDF User's Guides for SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. Before you ask: no, I can't say "when".
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
