|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-30-2005, 10:05 AM
|
|||
|
|||
|
ATI HDTV Wonder, will I get analog cable and OTA HD in Sage?
I was thinking about trying the HDTV Wonder Remote Control Edition in addition to my PVR-250 to get both a second cable tuner and a OTA HD. I know Sage supports the Wonder with OTA, but will it support the analog cable at the same time?
Anyone foresee a huge problems, I know getting the OTA signal might be hit and miss, but I'm confident that I will get at least a few in the Bay Area. 
|
|
#3
09-16-2007, 03:48 PM
|
|||
|
|||
|
Yes, the board has 2 tuners and two inputs. Connect the top one to your DTV antenna and the bottom one to your cable. Then in STV just configure each one for a different input, antenna vs cable.
FYI; some people have reported trouble using the auxillary input block with STV, but if you're only using the tuners there should be no problems.
__________________
"oderint dum metuant" ~Caligula:"Let them hate so long as they fear." Last edited by Paul H; 09-16-2007 at 05:26 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
