Main setup menu for HD200

[tvmaster2]

How do you get back to the setup menu that appears when the unit has been unplugged for a bit. Sorry, I must be daft, but I've looked all over and can't figure out how to do it bar unplugging the unit.
By the way - this thing pretty much rocks.

[tvmaster2]

so i finally found one post that mentions you can't get back to the standalone/setup menu unless you unplug the unit - really? is that true to the best of everyone's knowledge (newbee here)

[razrsharpe]

check the faq: http://forums.sagetv.com/forums/show...237#post323237

Specifically:

Start the STP-HD200 in standalone mode (not connected to a SageTV server).

• If the STP-HD200 is off, turn it on via the remote's Power button. If it is configured to auto-connect to a SageTV server, press Stop or Enter to cancel the connection when the 5-second delay dialog appears.
• If the STP-HD200 is turned on and connected to a SageTV server, press the Power button on the STP-HD200's remote to put it into standby mode, then press the Power button to restart it.
  
  Note: If the Auto Connect to Server option has been enabled in the HD200's SageTV Servers menu, then you will have 5 seconds to press Enter or Stop to cancel the auto-connect process when the unit powers on.

[tvmaster2]

Originally Posted by razrsharpe

check the faq: http://forums.sagetv.com/forums/show...237#post323237

Specifically:

Great info - thanks, I was looking all over for that. Cheers