|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-13-2006, 04:24 AM
|
||||
|
||||
|
How to prioritize tuners?
My server has two tuners, an old Roslyn card and a new PVR-150. The Roslyn card seems to be Sage's first choice and if that is not available it will use the 150. I want Sage to use the 150 first. How do I do that?
I've tried removing the Roslyn card from Sage and then re-adding it but that did nothing. Thanks for any help. 
|
|
#2
05-13-2006, 06:27 AM
|
|||
|
|||
|
|
|
#3
05-13-2006, 06:52 AM
|
||||
|
||||
|
Thanks for that. I never would have figured out to search on "merit".
I looked at my properties file and there is no setting at all which contains "mmc/encoders". The manual says the format should be mmc/encoders/XXX/encoder_merit but gives no clue on what XXX should be. How do I figure out what values I should use? Edit: Never mind, found it. I was looking at the properties file on the client instead of the server. I never did claim to be too bright..... Last edited by tmiranda; 05-13-2006 at 07:12 AM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
