|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-16-2003, 02:58 PM
|
||||
|
||||
|
irtune_repeat_factor and irtune_preroll
What are these properties used for? I'm hoping that irtune_repeat_factor controls how many times the IR signal for each button is repeated (ie, for how long the "button" is "pushed")? Would increasing this value make it less likely that my receiver will miss a channel change? Right now, it misses a channel change every 10 times or so. Increasing the delay between transmissions helped a bit, but didn't solve the problem completely.
What does irtune_preroll do? It would be very nice of all the properties could be documented somewhere, even if it is just a one liner for each property. The list on the site is hopelessly incomplete. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
