SageTV Community  

Go Back   SageTV Community > Members List

Notices

salsbst salsbst is offline

SageTVaholic

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. sundansx
    09-18-2011 07:04 PM
    sundansx
    salsbst,
    A while back it appears that you had sagetv setup with girder, with usbuirt blasting to your cable/sat box. I am in the middle of a move to windows 7 64 bit and am forced to move off of 1394 channelchange to use the blaster. How did you have this set up? I am an experience sage and girder user, so you can be technical. I went this route because I am likely going to move to a hauppauge cable card before long and need an interim solution.
    I am guessing that you have to use multitunerexe to send girder events. I presume you have to setup girder 11 girder actions that are all the numbers and an enter for the cable box. Even though sagetv has USBUIRT support, I am guessing that girder and sage cannot share the device at the same time.
  2. JScheiner
    12-14-2009 01:16 PM
    JScheiner
    No worries! Just sent you a message.

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 09-23-2016 04:42 PM
  • Join Date: 06-11-2003

All times are GMT -6. The time now is 07:05 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.