SageTV Community

SageTV Community (http://forums.sagetv.com/forums/index.php)
-   Hardware Support (http://forums.sagetv.com/forums/forumdisplay.php?f=9)
-   -   Restoring a Remote Control Setup (http://forums.sagetv.com/forums/showthread.php?t=37900)

BobMax 12-20-2008 11:24 PM

Restoring a Remote Control Setup
 
I am using a USB-UIRT IR receiver/Blaster and need to know how to restore the key setup for my remote control after an Un-install/Re-Install. I can't find a file that is changed when I make changes to the remote setup. I have saved the full sagetv directory so I hope it is just a matter of finding the correct file.

The Un-install/Re-Install is the only fix I have found so far for the transfer from my HDHomeRun stopping after 30 seconds or so and freezing the picture.

Opus4 12-21-2008 01:16 PM

Are you talking about the blaster portion to control an STB or just the remote to control the SageTV interface?

The IR codes assigned to each command for the UI are stored in the properties file on the ui/rc_mappings/<command name> lines.

- Andy


All times are GMT -6. The time now is 11:16 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.