|
|
|||||||
| Register | Forum Rules | FAQs | Members List | Social Groups | Downloads | Search | Today's Posts | Mark Forums Read |
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-28-2013, 04:38 PM
|
|||
|
|||
|
SageDCT No Encoders
I have a Ceton Infinitv 4 PCIe card that is working fine in windows media center. I installed SageDCT and copied the assignments into the sage properties file. I was then able to see the 4 encoders and assign a channel lineup to them. I can't tune them. It doesn't recognize these encoders. I looked in the recording schedule and they aren't there. I've turned of my Norton firewall, uninstalled it and tried the windows firewall on and off but no luck. I've put the sagedct.exe in the firewall as well as the port numbers for all 4 encoders.
Anyone know why I sage doesn't show the encoders? I'm using sage 7.1.9.256. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SageDCT 2.7.2 | sflamm | Hardware Support | 12 | 05-19-2014 03:09 PM |
| What is SageDCT? | ChePazzo | Hardware Support | 5 | 02-17-2012 08:49 PM |
| Where is SageDCT?????? | bjterry62 | Hardware Support | 4 | 02-10-2012 01:30 PM |
| More than 4 Encoders? | rleeson | SageTV Linux | 1 | 05-29-2008 04:52 AM |
| All encoders are in use? | mrwolf | SageTV Software | 4 | 03-01-2008 11:13 AM |
Linear Mode
