SageTV Community  

Go Back   SageTV Community > Hardware Support > Hardware Support


Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here.

Thread Tools Search this Thread Display Modes
Old 01-20-2006, 02:06 AM
mike1961 mike1961 is offline
Sage Icon
Join Date: Dec 2005
Location: California
Posts: 1,555
Hauppauge WinTV 500 Problem

Hello - I just bought two Hauppauge WinTV tuners. One of them works just fine but on the other one, only one tuner is working. The other keeps reporting No Signal when I try and view the channel when setting up the source. Also, sometimes when I turn on the computer I noticed that in the Device Drivers it could not always start the Tuner 2 device for that one card. If I disabled that tuner and then enabled it, it will then start. I put the card in another slot and sometimes on startup it still reports "This Device cannot start" in the device drivers. But, if I disable it and then enable it, the device drivers report that it has started. But the tuner still reports No Signal. I'm not sure if it's a software problem because I have two WinTV 500 cards in the computer or if it is more likely a problem with the card.

Any thoughts?


Last edited by mike1961; 01-20-2006 at 02:11 AM.
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 08:00 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2023, vBulletin Solutions Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.