Hauppauge 2250 HVR Issues

[joshabts]

Hello all,

I am having issues getting my 2250 to work properly in SageTV.

I currently have a PVR-500 dual tuner and another single tuner both tuning standard analog cable properly. I have added the 2250 to the PCI-e slot, installed the drivers and went to setup the source in Sagetv. I did realize that it shows up under a different name (7164) so I selected that. However it always just says no-signal when I choose the Digital TV Tuner. If I select the regular "TV Tuner" I get all my standard channels I tune on the other tuners already installed. However no matter If I pick the #1 or #2 of the 2250, Digital TV Tuner always never tunes and if I bypass the initial page where it shows a preview, and go to the channel lineup they all say No Signal with signal strength 100%.

I have installed the Beta drivers for the 2250, as found at ftp://hauppauge.com/Support/HVR2250/ and with the shipped 4.7 drivers as well as the drivers found at that link I get the same result.

I did install WinTV and it was able to find Digital channels, so I know there are channels available.

I have also installed the beta files for the DShow and TSplitter, same result.

I did reboot after every step and change I made so I know it is not that.

Any ideas or suggestions? I was really looking forward to some HD shows tonight, but looks like it will be waiting a little longer yet...