![]() |
|
SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
![]() |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
![]()
Any help is greatly appreciated.
I have 3 PVR 250's in my box. I installed SageTV and then the cards, one at a time. The first card I configured to let the external cable box tune the channels so that I can record the digital channels. I have a MyTv USB Ir tuner installed that changes the channels on the cable box. Everything worked fine. Until I added the other tuners. I set them up to do their own tuning. Now, I can't get digital and the channels don't change on the box. It is as if Sage can't figure out to use that card on channels over 100. I just had an idea that maybe I need to disable all of the channels below 100 on the source that uses the cable box. I'll try that later, but if any of you have a configuration working with 1 internal tuner and 1 external tuner, I would like some help. Larry |
#2
|
||||
|
||||
Did you set up the card hooked up to the cable box and THEN set up the other cards? If so, I would recommend setting up all cards first, then as a last step set up the cable box device. I had some problems with the device numbers changing as new tuners were added.
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|