|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#2
02-21-2005, 08:22 PM
|
|||
|
|||
|
I did the same addition about a month ago and there was absolutely no problems. When the computer booted it found the new hardware and I installed the drivers from the CD. I could not have been easier. The setup in Sage went smoothly as well with no configuration problems.
|
|
#3
02-21-2005, 09:11 PM
|
||||
|
||||
|
If you are using the Hauppauge remote via the IR receiver on the 250, adding a 150/250/500 mce version, which has no remote, _might_ make it near impossible to get the actual card w/a remote to be chosen by the IR software... so you could lose use of the Hauppauge remote. Some people seem to be lucky and have no such problem. That's about the only 'gotcha' that I'm aware of.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
