|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-28-2005, 11:19 AM
|
|||
|
|||
|
Mapped drive problem
When I try to change the directory in which files are saved, my mapped network drives are not shown.
I think it is some sort of bug in the software, only because I did have another install where the mapped drives were shown. Any thoughts on how to fix this. 
|
|
#2
04-28-2005, 11:29 AM
|
|||
|
|||
|
Are you using sage as a service ? If so you need to manually enter the complete path.
For example, if the shared drive is "sage" on a computer named "pc1" then you need to use the path \\pc1\sage Gog
|
|
#4
04-28-2005, 12:14 PM
|
||||
|
||||
|
To go along with what was said above, the service needs to use UNC paths to access network drives. See pages 14-15 in the v2.2 manual for more details.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
