|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
07-06-2005, 04:41 PM
|
|||
|
|||
|
Sage TV v2.2.7 file sizes
My apologies if this has been posted, I was not able to find the topic in a search.
I have a Hauppauge 250 pvr, but that does not seem to be the issue. When I first purchased SageTV, the estimated file sizes were displayed next to each recording setting in the Setup Menu. Since I upgraded to v2.2.7, those file sizes are no longer displayed. Should they be displayed (is this a fluke)? Or was this intentional? Either way, is there a way to find the estimated sizes without trying each one? Thank you (and hopefully this is in the right forum) Last edited by Nooner; 07-06-2005 at 06:55 PM. 
|
|
#2
07-06-2005, 04:47 PM
|
||||
|
||||
|
You mean the GB/hour shown when choosing the recording quality setting? Those aren't displayed any more in v2.2, but it has already been requested to have that info put back into place.
The bit rate is in the properties file & has been listed several times on the forum, if I could just find an old post... - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
