|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-27-2005, 09:02 PM
|
||||
|
||||
|
Cannot Change Remote Control Options
I had to reinstall Sage 2.2.8 and am finding that I cannot change any of the Remote Control Options (such as "Delay between codes") It lets me type a number but then it doesn't "take". Almost like the properties file is read only or something.
I was running the Service but then thought that might be a problem so switched back to non-service mode to see. Have tried updating the JRE to Update 5. Any ideas? 
|
|
#2
09-27-2005, 09:11 PM
|
||||
|
||||
|
OK, I noticed that you cannot change the remote options on the "Stock" DCT2000 Motorola, but I can change them if I add a new box. Hmmm... Is this by design?
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
