|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-28-2005, 02:40 PM
|
||||
|
||||
|
java crashes in v4
hey, I have upgraded to v4 and love it so far.
only thing that is a nuisance is a sun jave crash, I seem to get pretty regularly after sage has been running (even in sleep mode) for a bout 48 hours. It causes sage to hang and send an error report to MS error reporting. i dont even mind that, it's just that if it happens when I am not around, all my recording schedule goes to crap. too bad there wasnt a trigger one could setup to detect an application death, and relaunch it. Or better still, a fix from Sun or Frey for this. I am using the newest jave (1.50 i think)... I notice that sage comes with 1.46... maybe I should roll back?
__________________
XP Pro SP2, P4 2.6 ghz, 1GB RAM, 2 X 80GB seagate serial ATA barracuda HDDs,2 X 160 GB samsung silent parallel ATA HDDs, antec sonata v1.1, msi gforce 6600gt vivo, hpage pvr150, sagetv v5, harmony remote, hauppauge media mvp, USB UIRT, Bell Expressvu 
|
|
#2
11-28-2005, 03:06 PM
|
|||
|
|||
|
SageTV v4 will run fine with Jave 1_50 Update 5, as posted by Sage in a thread of mine. If you're using service mode, a crash in the UI shouldn't cause a problem with the service recording. I'm running 1_50_5 without a problem...I uninstalled all earlier versions (they stay installed even when upgrading, unless you remove them).
P
|
|
#3
11-28-2005, 05:23 PM
|
||||
|
||||
|
ok, too bad the UI has to crash then.
__________________
XP Pro SP2, P4 2.6 ghz, 1GB RAM, 2 X 80GB seagate serial ATA barracuda HDDs,2 X 160 GB samsung silent parallel ATA HDDs, antec sonata v1.1, msi gforce 6600gt vivo, hpage pvr150, sagetv v5, harmony remote, hauppauge media mvp, USB UIRT, Bell Expressvu
|
|
#4
11-29-2005, 03:33 AM
|
||||
|
||||
|
I had the same issue after upgrading, and tried rolling back/forward java, turning on the debug logging and working with Sage Support. Three weeks of trying, but no luck...
Backed up the wiz.bin, reinstalled a fresh copy of XP, installed the 4.0 version of Sage (no upgrade) and all these problems went away. Not the easiest resolution but one none the less.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
