|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-02-2005, 09:34 PM
|
|||
|
|||
|
Time Issue, Please HELP!!!!
I just got my hardware today and made a huge mistake. I got done building my server. Time was not synced yet and I installed Sage. When I rebooted, time synced via NTP and now Sage thinks I'm trying to get around the copy protection. I even have a Server Key I purchased, but did not enter yet. How can I fix the error?
"Your system clock appears to have been set back....." code CCB-F Regards, Deliverer 
|
|
#2
12-02-2005, 10:29 PM
|
||||
|
||||
|
So, you mean it just gives the error message & exits w/o asking for the license key? Try using the REGISTER command line parameter with sagetv.exe -- see p. 230 of the PDF manual in your SageTV dir for details.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
