|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-06-2006, 08:34 PM
|
||||
|
||||
|
Setting up Source - Buttons Missing???
I decided to go ahead and try out 4.1 tonight. So I completely uninstalled 4.0, and deleted all traces so I'm starting clean.
I install 4.1, enable the Service, etc. Then when I go into source setup, I configure it for Comcast Digital Extended Basic...it thinks for a while...then finally after a full minute it shows a channel lineup. But what do I do now??? It looks like I'm missing a "Complete Channel Setup" option. FWIW, this is on my server. Windows 2003 Server. Athlon XP1800 on K7Sd pro motherboard. ATI 7200 video card Help??? 
|
|
#2
01-06-2006, 11:02 PM
|
||||
|
||||
|
I had this problem intially with my installation of 4.1
I ended up reconfiguring my setup, and when I installed the server on another machine I didn't have the problem any longer. I sent in a ticket and was asked for more info I think. You should report it to support aswell.
|
|
#3
01-06-2006, 11:42 PM
|
||||
|
||||
|
OK I got it to work finally. Basically, what I did was to ALT-F4 out of everything. Then I ran the service control app and disabled the service so that I was just running SageTV normally. Once I did that, everything worked correctly.
Once I got everything configured, I went back and re-enabled the service and now all seems to be OK. Maybe there was some initial configuration/initialization that needed to occur before the service knew about my channel line-up. Anyway, all looks good now.
|
|
#4
01-08-2006, 09:12 PM
|
||||
|
||||
|
On a clean install you don't want to enable the service before you configure Sage. If you were doing an upgrade to your installation that would be fine to do.
Gerry
__________________
Big Gerr _______ Server - WHS 2011: Sage 7.1.9 - 1 x HD Prime and 2 x HDHomeRun - Intel Atom D525 1.6 GHz, Acer Easystore, RAM 4 GB, 4 x 2TB hotswap drives, 1 x 2TB USB ext Clients: 2 x PC Clients, 1 x HD300, 2 x HD-200, 1 x HD-100 DEV Client: Win 7 Ultimate 64 bit - AMD 64 x2 6000+, Gigabyte GA-MA790GP-DS4H MB, RAM 4GB, HD OS:500GB, DATA:1 x 500GB, Pace RGN STB.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
