|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-06-2006, 09:22 PM
|
||||
|
||||
|
Multiple displays - can UI start on secondary by default?
I have two GeForce 6600 cards, each connected to two displays. Three monitors and one HDTV. The television isn't set as primary for obvious reasons but I would like it to be the display that Sage loads to. I've recently upgraded to SageTV v4 from v2. Version 2 simply loaded on the display it was last on, however v4 always wants to load on the primary. Is there any way (through Sage or system) to manually set which display the UI will load to?
|
|
#2
01-06-2006, 11:46 PM
|
||||
|
||||
|
Are you using FSE mode, which has to be on the primary monitor? My SageTV windows all start on the screen where I last left them before exiting. I don't use FSE.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
01-07-2006, 03:10 AM
|
||||
|
||||
|
Yeah, that's the strange thing. I'm not using FSE. Just plain old overlay. Should have included that in my first post. I'm not sure if this has anything to do with another issue I've encountered since upgrading to v4.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
