|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-28-2006, 05:48 PM
|
|||
|
|||
|
Help with setup
I just received the SageTV bundle with the AverTV HD MCE A180 and need to know how to set it up with Dish Network. The software is installed properly but I don't get a signal except what the receiver is tuned to. Is there anyone out there that is using SageTV with the Dish Network HD receiver? I thought I could set it up to record different programs at different times. If I use the guide it shows no signal except for the channel the receiver is tuned to. Help if you can.
|
|
#2
02-28-2006, 05:55 PM
|
||||
|
||||
|
When using an external tuner, you have to provide some way for SageTV to be able to change the channel on the tuner box -- usually either an IR blaster or serial cable.
(You will only be recording HD via OTA signals, though. Not sure if you knew that.) - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
