|
|
|||||||
| SageTV Beta Test Software Discussion related to BETA Releases of the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. regarding SageTV Beta Releases should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-30-2006, 10:36 PM
|
||||
|
||||
|
PVR 500 Only Sees one tuner 4.1.10
I recently had to replace my motherboard. while re-configuring SageTV, I killed the process while Sage was starting. I must have corrupted something because when I started it again, it had lost all settings. I went to set up video sources and the second tuner isn't seen anymore. Any suggestions?
|
|
#2
03-30-2006, 10:45 PM
|
||||
|
||||
|
Unless you have a lot of stuff configured already, I would just get rid of the properties file & its autobackup, then start the SageTV config process over again, just to be sure everything gets setup up properly after killing it during startup.
Otherwise, maybe one of the tuners got stuck in the mmc/ignore_encoders properties line -- you can remove that entire line & start over if you don't want to remove the properties file. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
