|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-10-2006, 05:42 AM
|
|||
|
|||
|
Tuning OTA HD
I just installed an antenna for my A180 and am able to pull in some OTA HD signals. When I am in channel setup, it tunes the channels fine and I can see them in the preview window. I remap the channels to a high, unused number (e.g. 207). When I go to Watch Live TV, it only tunes the last channel that I viewed on the setup screen! In other words, I change to channel 214, but it still shows 207, etc. The standard cable channels tune in fine. Help!
|
|
#2
04-10-2006, 06:28 AM
|
||||
|
||||
|
Are 207 & 214 the actual channel numbers that should be used? Remapping is used to fix a channel number that is incorrect, not to place the channel at some arbitrary number for sorting purposes. Since you said tuning worked fine before remapping, clear the remapping to put them back where they were.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
04-10-2006, 06:45 AM
|
|||
|
|||
|
Yes, it works if I clear the mappings. I was just trying that.
Is there some way to put the channels at another location in the guide so they don't conflict with the cable channels? I'd also like to make it easy to remember the channels by say putting the HD version of channel 7 at channel 207. Thanks.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
