Configuration Wizard won't stop

[dshields]

I reinstalled SageTV completely. In order to make it through the setup I disabled the SageTV service. I got things working and set the service up again and started it. A little while later I started the SageTV application and it went into the configuration wizard at the beginning ("Select your Country").

I checked Sage.Properties, and I have this:
ConfigWiz/MCFullyConfigured=true

What's going on?

[ToxMox]

You configured it in non service mode so all those changes were made to sage.properties Now that you switched to service mode you probably need to make the same changes to the sageclient.properties file.

[dshields]

Originally Posted by ToxMox

You configured it in non service mode so all those changes were made to sage.properties Now that you switched to service mode you probably need to make the same changes to the sageclient.properties file.

What is the best way to do that? I can't go thru the setup wizard because that's a catch-22. I was forced to turn off the service because setup fails when the service is running. But now when I turn the service on, I am forced to run setup again - which I can only complete successfully by turning the service off!

[ToxMox]

Did you attempt to go through it. The lineups should already be there from when you set it up in non service mode. It is only simple things about the client interface that it may need info on such as Country etc.

[dshields]

Originally Posted by ToxMox

Did you attempt to go through it. The lineups should already be there from when you set it up in non service mode. It is only simple things about the client interface that it may need info on such as Country etc.

With your encouragement, I tried it. You were right. After all my problems, I was afraid of screwing up the settings by running the wizard again; but I was able to skip over the video source setup and now I think things are set up properly. I appreciate your help!

[ToxMox]

No prob. Hopefully your problems will be gone.