|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
05-19-2006, 11:55 AM
|
||||
|
||||
|
Hauppauge Remote Control problem - Sage v2.1
I recently had some user profile issues on my Sage box. To make a long story short I have that fixed. Now Sage loads and works fine but the Hauppauge remote control will only jumps from the top to the bottom or bottom to top of any window, no scrolling just back and forth when I press the up and down buttons. No other controls work. I am fully functional with the mouse.
Things I have tried: 1. Reinstalled the IR software from the Hauppauge disk 2. Restarted the IR service 3. Repaired Sagetv v2.1 (Cayars17) 4. Changed the IR input to another card (have 3 PVR-250's) 5. Restarted to many times to count. 
__________________
|
|
#2
05-19-2006, 12:04 PM
|
||||
|
||||
|
You need to modify irremote.ini to enable it to control SageTV. See this FAQ, and/or the Hauppauge links in my sig lines -- post 3 of link 1, or post 15 of link 3.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
