|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-24-2006, 12:37 PM
|
|||
|
|||
|
live tv strange behavior
i have sage tv server with pvr 150 plus blaster.
I have also sage tv client in my bed room connected via lan. when i watching live tv and choose to change channel(by up\down channel via remote or by typping the channel number and press ok) the picture is freeze for a several seconds and after it , it replace the channel without problem why I this stop between changing channels? thanks 
|
|
#2
06-24-2006, 01:01 PM
|
||||
|
||||
|
There will be a bit of a delay as SageTV begins to record the new channel & buffer it for a bit before the new channel can begin playing. Plus, in your case it has to wait for the IR blaster to finish changing the channel. The delay is probably a little bit shorter when using the tuner built into the card instead of an external receiver, but there is still a delay.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
