|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
07-28-2006, 07:54 PM
|
|||
|
|||
|
Hauppage PVR 150 IR Blaster
Hello. Can someone tell me if two PVR 150 cards IR blaster can be used in the same system to control two separate satellite receivers? I thought I had read previosly that this would not work, but maybe thats not right, or perhaps the drivers have been made for this to work....
|
|
#2
07-28-2006, 09:00 PM
|
||||
|
||||
|
Unless Hauppauge has done a major update on the drivers (which I don't think happened), only a single card's IR blaster and/or receiver can be used.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
07-28-2006, 09:08 PM
|
|||
|
|||
|
Thanks, I just installed the second card and the blaster only works on whatever card is seen first.
 Wish I had known that before hand, would have just gotten the MCE cards instead.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
