|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
07-31-2006, 09:12 AM
|
|||
|
|||
|
moving the PVR 150 source to the last priority
I have a PVR 150 and a PVR 500 now all working great since I got the cable strength input right.
Sage does a great job switching between tuners, except for 1 small clitch that I have found. I have both coax from the street and Svideo from the cable box plugged into my PVR 150. If I am recording just 1 show, Sage seems to always use the 150first. So, when I try to watch something via the Svideo from the cable box while recording 1 other show, Sage will not because the 150 is already being used. I think I need to somehow put the 150 as the last priority of the 3 tuners, thus allowing me to use Svideo when up to 2 tuners (PVR 500) are being used. Any solution? Gary 
|
|
#2
07-31-2006, 03:05 PM
|
|||
|
|||
|
the setting you need is "encoder_merit" in sage.properties. YOu can specify the order you would prefer Sage use the tuners. If you set the 150 as 0 (zero) and the 500's tuners as 1 and 2, then Sage would normally use the 500's tuners and leave the 150 free as long as possible.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
