|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-16-2006, 04:47 PM
|
||||
|
||||
|
upgrading or re-installing
When either upgrading to a higher version, or re-installing the same version, what needs to be done to ensure that all the programs currently recorded and stored can be accessed again after the upgrade?
|
|
#2
08-16-2006, 04:51 PM
|
||||
|
||||
|
There's an FAQ about it, but basically, nothing, Sage doesn't nuke anything on re-install/upgrade.
The sage.properties, sageclient.properties, and wiz.bin contain all your info, so you can back them up to be safe.
|
|
#3
08-16-2006, 05:11 PM
|
||||
|
||||
|
The Beta Test forum section has a sticky about how to install an upgrade & covers making a complete backup... but those most important files that stanger mentioned are automatically backed up when you first run a new version -- it creates copies of them, adding ".SageTV v<old version #>" to the end of the filenames.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
