|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-11-2006, 08:19 PM
|
|||
|
|||
USB-UIRT / DirecTV Setup
I now have two new DirecTV tuners with no serial inputs unfortunately. Is there a way to control both of them with one USB-UIRT or will two be needed and the tuners physically separated to avoid channels being turned on both receivers at the same time? Any information would be greatly appreciated before I purchase the USB-UIRT.
Best regards, Craig Hickman 
|
|
#2
09-11-2006, 09:04 PM
|
||||
|
||||
|
The Information Resources for Remotes, Receivers, and IR Blasters sticky post in this forum has some links for the USB-UIRT. In short: there is a way to control up to 3 devices that all use the same IR codes with a single USB-UIRT, but if you can configure them to use different IR code sets, you can control more.
If they are the same IR code set, you'll need external emitters & block each one from affecting the other box. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
