SageTV doesn't remember Keyboard settings

[andrewswright]

Hi,

I've set up a MCE remote to control SageTV through Girder, which works great. The problem is that some buttons on the MCE remote also send num+ keys. For example, Volume up both increases the volume and sends num+3. SageTV then gets a 3 command.

If I unlink the num+3 keyboard command from "3" in the advanced setup options then SageTV never sees the "3." This works until I put Sage to sleep and wake it up again. At this point num+3 is again linked to 3 in the advanced setup dialog. No matter how many times I unlink the keyboard command, it always pops back again. This is also the case if I quit SageTV and restart.

I've even tried editing the Sage.properties file. I wasn't sure which setting to change manually, so I deleted the Keyboard accelerators line, to no effect.

Any ideas?
Andrew