|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-28-2006, 08:40 PM
|
|||
|
|||
|
channel change without enter?
i use a usbuirt with sage, and i have max digits set to 3 in remote control options.
when i want to change to say channel 1 i have to press '1' and then my enter button, or i have to press '001'. when i just input '1' and wait, nothing happens and the osd eventually times out. its basically 3 digits or bust. is this normal behavior? is there anyway to have the channel change when x amount of time has passed after 1 or 2 digits are pressed? forgive any noobishness 
|
|
#2
12-28-2006, 11:37 PM
|
||||
|
||||
|
I also have a problem with usbuirt. I just enteres too many numbers, and doesnt get to the right channel.. It's worked fine in the the past, for over two years. It only started to happen after I reverted back to version 5 of sage. I then tried ver. 6 again and it still did it... any one have any ideas..
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
