|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-06-2007, 04:29 PM
|
|||
|
|||
|
Cannot change Server channel while Client is viewing TV
When I have my client viewing live tv from my server, I cannot change the channel on the server. Is this normal? I have to (on my client) goto the main menu (stop viewing signal) before the server will change channels. I am assuming I have a config issue, as it cannot intentionally restrict like this. Please help.
Thanks, Smoke 
|
|
#2
01-06-2007, 04:44 PM
|
||||
|
||||
|
This is normal. One client cannot change the channel on a tuner that another client is using for live TV, unless there is another tuner that is available to use for the recording instead. (In this case client = any SageTV UI.)
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
01-06-2007, 04:46 PM
|
|||
|
|||
|
So channel surfing while the client is connected (viewing) is out of the questions without multi-tuner.?. Well, it is what it is I suppose.
__________________
Smokescreen
|
|
#4
01-06-2007, 04:47 PM
|
|||
|
|||
|
Thank you for responding so quickly!
__________________
Smokescreen
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
