|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-08-2007, 10:23 PM
|
|||
|
|||
|
Setting for hardware encoder?
Hello,
Is there a setting or anything that needs to be done to ensure that SageTV uses the hardware encoder on the Hauppauge 250 opposed to some default software solution? What about for decoding? I just want to ensure I have set up my system as resource efficient as possible. Thank you. 
|
|
#2
02-08-2007, 10:42 PM
|
||||
|
||||
|
The Hauppauge PVR-250 is a hardware encoder. If you are using it with SageTV, it is doing hardware encoding; no special setting required.
Decoding is handled by the decoder settings, which may depend on which type of SageTV client you are using. The 250 has no decoder. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
