|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-26-2007, 08:22 AM
|
||||
|
||||
|
Over-Air HD and Basic Cable Mix
Hauppauge has a new WinTV-HVR-1600 tuner that will let you receive both cable channels are over the air HD. In my situation most of the local channels are available in over the air HD, but I also want to be able to tune to my basic non-HD cable channels. Is it possible to configure the SageTV program guide to use the HD receiver for local channels and then the cable receiver for all the other channels? I want to seemlessly surf between standard format and HD.
|
|
#2
02-26-2007, 09:36 AM
|
||||
|
||||
|
Not quite the same thing, but with the HD Homerun, the HD OTA channels and the HD QAM channels appear as one channel (they don't duplicate) and are part of the same channel list, so based on that I think you can do what you want.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HDHomeRun success story | jbarr | Hardware Support | 9 | 02-22-2007 04:46 PM |
Linear Mode
