Factory reset ?

[willplaice]

I've upset one of my hd200's is there a "factory reset" ?

[gplasky]

Originally Posted by willplaice

I've upset one of my hd200's is there a "factory reset" ?

Look in the FAQs.

HD200 doesn't work

Gerry

[willplaice]

ok thanks for the RTFM comment....
re-read that thread, still can't see anything... is there some way to reset the settings to default.

If the USB recovery method will reset EVERYTHING then i'll do this, but i need to be sure that all the settings exp video will get wiped before i go down this route.

thanks ,Will

[gplasky]

Originally Posted by willplaice

ok thanks for the RTFM comment....
re-read that thread, still can't see anything... is there some way to reset the settings to default.

I guess I could read it to you.

From the thread:

Q: My STP-HD200 extender is not working at all. What should I do?

A: Try the recovery procedure if nothing else works.

First, check the Troubleshooting Guide in the printed manual that came with your STP-HD200, or in the PDF manual available here: SageTV_HD200_Manual.pdf (Right click & choose "Save Target As...")

From the manual

Configuration Reset Procedure
If none of the other troubleshooting suggestions have solved the problem, then you can try this
Configuration Reset Procedure:
1. Turn the player off by unplugging the power cable.
2. Press the Delete button on the remote and continue holding it as you plug the power cable
back in. Continue holding the Delete button until the Active light blinks twice.
3. Note that you may need to use the Video Out button on the remote to change the video
output resolution.
4. After the reset procedure, check the above troubleshooting tips again.

The USB recovery is the NEXT step if the above doesn't work.

Gerry