|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-14-2010, 10:49 AM
|
|||
|
|||
|
"No Signal" from comcast into HDHR and cannot start playback..
So here's my bug of the day.
 As we've been having a massive storm I *just* lost my Comcast cable feed for the time being. Decided to go and start playing back a recording that was going on at the time. I have about 30 minutes recorded so far and wanted to at least watch that, but with the cable feed lost when I start playback (with the time bar sitting at -04:59 btw) I get the "No Signal" Screen and Sage will NOT play back what I have so far at the moment. Why not? I'd think it should at least let me play back what I have and then report a signal lost when it gets to the red section as shown on my progress bar, but nope no playback at all. Any thoughts?
__________________
Setup #7.6  Hyper-V (again!)Hardware: Comcast Basic Digital Cable, (1) HDHR3-CC 20170815 firmware, 36GB "system" drive, 2TB laptop drives, a buttload of archive drives, HP DL380G6 2x X5660 processors (4 cores to VM), 4GB ram Software: Windows 7 Ultimate SP1 x64, SageTV v9.1.2.662, Java v1.8.0_131, STV 2017052101, HD300 extenders 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "No signal" in Windows 7 on almost all channels (HDHR OTA/QAM, etc.) | gtd885a | Hardware Support | 24 | 07-09-2009 10:49 AM |
| channel lineup problem "comcast howard county digital" | deruberhanyok | SageTV EPG Service | 5 | 09-10-2008 07:56 PM |
| "Set defaults" for Series forgets "Keep"/"Auto-delete" setting | maxpower | SageMC Custom Interface | 9 | 05-14-2008 09:44 PM |
| "No Signal" with 100% signal strength | trini0 | SageTV Software | 3 | 03-17-2006 12:01 PM |
| Stutter/Jitter using A180/Vbox and OTA? Check signal "Strength" not "quality" | svemuri | Hardware Support | 0 | 12-13-2005 10:51 AM |
Linear Mode
