|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-24-2010, 06:33 PM
|
||||
|
||||
|
Hauppauge 2250 no channels in Win7 64bit
I have a dual boot system with XP-Pro 32bit and WIN7 64bit. I tried a complete scan and it found no channels. I copied the frq and scn files from the XP install and still no luck...
I have the latest version of Sage install and this is a fresh install on Win7 Enterprise 64bit
__________________
If this doesn't work right, Then: "I'm going to blow up the Earth!" 
|
|
#2
03-24-2010, 06:53 PM
|
||||
|
||||
|
Are you running the drivers that MS loaded during the install or the drivers from the Hauppauge web site?
IIRC, I had problems with the MS drivers but ended up OK with the Hauppauge drivers. I was doing OTA ATSC only (you didn't mention ATSC vs QAM). And I'm on Win 7 32bit. EDIT: This whole thread is on the 2250 but much of it is from before Win 7. But there's some info a bit before and after this post: http://forums.freytechnologies.com/f...&postcount=147
__________________
Server: SageTV 9, Win10/32, Intel DP55KG Mb, Intel QC i5 2.66GHz , 4GB 1333MHz DDR3 SDRAM, 2 Hauppauge 2255s for 4 OTA ATSC tuners, HDHRPrime w Comcast, 3 STP-HD300s 20101007-0 firmware, nVidia Shield. Java v7u55. Plugins:SD EPG, OpenDCT Last edited by HelenWeathers; 03-24-2010 at 07:41 PM.
|
|
#3
03-28-2010, 09:34 AM
|
|||
|
|||
|
Exact same problem. Any solution to this yet? Ironic the timing isnt it? I am using the Hauppauge drivers.
I have Win 7 64-bit with a HVR-1800 and HVR-2250. The 1800 sees QAM channels fine, but a scan with the 2250 yields no results. I have also copied the freq files over.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie setup question - 2250, Win7 x64 | hijakk | Hardware Support | 5 | 03-14-2010 01:00 PM |
| hvr 2250 analog recording quality w7 64bit? | JonTom | Hardware Support | 1 | 12-06-2009 03:55 PM |
| Problem when running in Win7 64bit | rdefino | SageTV Software | 1 | 11-30-2009 12:47 PM |
| Hauppauge 2250 and recording 2 channels from cable box | bphillips41 | Hardware Support | 10 | 06-13-2009 07:20 AM |
| Server 2003 64bit drivers for hauppauge 1800?? | CaptSammy | Hardware Support | 0 | 02-16-2008 07:45 PM |
Linear Mode
