All 4 extenders are not working

[jtbellush]

Last week all of my extenders quit working in extender mode. I have two 200's and 2 300's. Each of them says they are connecting to my server, then nothing. All TV's say no signal or no input. I have tried everything with them. I am a bit more concerned than usual since all 4 are freezing at the same place and not working. Any advice would be much appreciated.

[thomaszoo]

My guess is a network problem.

Wayne

[gplasky]

Originally Posted by thomaszoo

My guess is a network problem.

Wayne

Agreed. Switch going bad. Firewall settings changed on the Sage server. Find the IP of your extenders and make sure you can ping them from the network and then try pinging from the Sage server.

Gerry

[hoep]

Originally Posted by jtbellush

Last week all of my extenders quit working in extender mode. I have two 200's and 2 300's. Each of them says they are connecting to my server, then nothing. All TV's say no signal or no input. I have tried everything with them. I am a bit more concerned than usual since all 4 are freezing at the same place and not working. Any advice would be much appreciated.

do you run phoenix and updated to the 409 release - i had the same issue with all boxes when doing this and had to revert back to the 408 release. there is a thread in the phoenix subforum...

[Mitch G]

I know it's asking the obvious, but did you try rebooting the server?
I've had this sort of thing happen - I think due to a memory issue - and things were fine.


Mitch