|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-30-2004, 09:02 AM
|
||||
|
||||
|
werid osd problem
Hi,
I have a 350. When I enable OSD, all seems okay, apart from I dont get anything on the screen! (video is there, but no OSD info) However, I do get a black bar running along the bottom of the screen, about 1/4 high. If I go back in and turn of OSD, it stays there until I reboot the system. Anyone else had this one? Simon. Last edited by edgley; 06-30-2004 at 09:04 AM. 
|
|
#2
06-30-2004, 09:14 AM
|
||||
|
||||
|
Check out this thread: Black bar with pvr 350, specifically around the 4th post from the bottom or so. Does that help?
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
