|
SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
Semi new Sage user has a couple questions
I recentlly picked up Sage 2.0 and a roslyn PVR card. Its been doing what it should pretty well sicne I got it. With my main problem being that it will not even allow my monitor to go into power saving mode.
I know Sage doesn't play well with power saving, and I suppose I can understand it for stuff like standby and whatnot, but why won't it let just the monitor power down, it doesn't need the monitor to do its thing, any help? Also, about recording quality, is there any way to set it up with differan trecording qualities for differant shows? I want most stuff to be relatively high quality, but some stuff, like say the Simpsons, I would prefer to be lower quality, since it is recording like 10-12 episodes a week. So if I change the recording quality for the simpsons(set as a favorite)will it leave the rest of the shows at default quality? |
#2
|
||||
|
||||
Re: Semi new Sage user has a couple questions
Quote:
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. |
#3
|
|||
|
|||
set the power management to presentation mode and see if it works
also try reenabling the disable pm property I got it to work last time from just working at it |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|