|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-08-2004, 09:17 AM
|
|||
|
|||
|
Navigate pictures in fullscreen
Newbie question:
When I select a picture from the Library and it goes fullscreen, I can't seem to navigate to the next or previous picture. It seems awful strange that I would not be able to do that. Am I missing something? Geoff 
|
|
#2
10-08-2004, 09:32 AM
|
||||
|
||||
|
See page 92 of the manual for details of picture viewing. If you are viewing an individual image, there is no fwd/back, since you are viewing a single image. You can use some commands to move around during a slideshow.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
10-08-2004, 11:17 AM
|
|||
|
|||
|
thanks.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
