|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-26-2004, 11:01 AM
|
||||
|
||||
|
Sendmessage.exe and Girder
I'm trying to setup a "No Focus" SageTV commands for my remote through Girder. Basically, remote sends command to Girder, Girder then executes the sendmessage.exe command follow by the SageTV event #. I'm lost with Girder as what actions to use or how to setp up the event #. Any help appreciated, especially if someone already done this and could just send me the Girder GML file. Thanks.
__________________
Mayamaniac - SageTV 7.1.9 Server. Win7 32bit in VMWare Fusion. HDHR (FiOS Coax). HDHR Prime 3 Tuners (FiOS Cable Card). Gemstone theme. - SageTV HD300 - HDMI 1080p Samsung 75" LED. 
|
|
#2
12-26-2004, 11:21 AM
|
||||
|
||||
|
See the info stanger89 posted on the SageTV Community wiki about Girder setup for remote controls.
Also, Girder has a SendMessage plugin that you would use; you don't use my SendMessage.exe utility, if that was what you were referring to. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
12-26-2004, 11:44 AM
|
||||
|
||||
|
Exactly what I'm looking for. Thank you, Andy.
__________________
Mayamaniac - SageTV 7.1.9 Server. Win7 32bit in VMWare Fusion. HDHR (FiOS Coax). HDHR Prime 3 Tuners (FiOS Cable Card). Gemstone theme. - SageTV HD300 - HDMI 1080p Samsung 75" LED.
|
|
#5
12-26-2004, 08:02 PM
|
||||
|
||||
|
SageTV doesn't use wParam, as shown at the bottom of p. 151 in the v2.1 manual. (A lot of the manual is cross-referenced: there are links to that page from the SendMessage appendix, for example.)
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
