Channels all the same Sage 2.1

[Donnod]

New to the Sage universe, and will probably continue to be...if I can get this problem fixed.

I have a single cable connection into Hauppauge PVR 350 (no cable box, not needed) Have set up Sagetv 2.1 as specified. All channels display the same program. ALL of them. I can change the channels - no problem, but they're all the same (channel 47 from local cable company) Have reinstalled twice. Looked over my settings, but to no avail. All else seems to work ok. WintTV2000 works fine as well, so I know the card is working. Any ideas?

Also, OSD is too large. Edges are being cut off, even after I have adjusted it left and right.

P4 2.66 w/512mb
Geforce 4 4200ti w/128mb
WinXP Pro
Sage 2.1
Hauppauge WinTVPVR 350 - driver v. 1.18.21.22266

Thank you for your time.

don

[Donnod]

I finally figured out the OSD adjustments. I should have paid a bit more attention to what I was doing. Still trying to figure the same channel problem out though.

[Donnod]

Sorry to bug all again. Reinstalled all drivers and apps for the fourth time. It worked this time around. Not sure what the problem was.

thanks

[LowTech]

Dunno if this'll help, but if in the future you run across this issue again go to channel set up and disable one channel (make the green ball dissapear) and re-enable it. This will download EPG data again. Might work next time, if there is a next time.

Good luck.